You can try to repair the flashlight quickly with the following steps. This issue could occur when iPhone gets dropped or wet. IPhone faulty rear camera flashlight is another common hardware problem for many users. However, if you replace the home button on your own, the touch ID feature is not available you need to go to the Apple Store to enable it. If the home button is broken, buy a new one and replace it.Check whether the cables and the button are untouched. Take apart your iPhone screen just like part 1 and then loosen the screws around the Home Button.When there’s something wrong with the cables or the home button, you’ll not get any responsive from iPhone display. There are 2 cables that connect the home button with the logic board. If the iPhone home button not working after dropped or water damage, hardware problem is the real reason. When your iPhone entered recovery mode successfully, click “Exit Recovery Mode”. ![]() Once your iOS is detected, click “Enter Recovery Mode”. When you remove the front screen, put the new screen on your iPhone and then screw every parts to their original places.ĭownload and install the program on Mac or PC, run Tenorshare ReiBoot and connect iPhone to computer. Remove the battery connect bracket screws and the front panel assembly cable bracket screws to separate front panel assembly from the rear case. Then stick the plastic sucker on the screen and use the knife to open the screen. ![]() Use the screwdriver to loosen the screws aside the charging port.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |